This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
X25-M G2 Update failed, reboot, says firmware already updated
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2009 12:52 AM
I tried to update the FW and it failed, saying I should boot up in legacy IDE mode (I'm using ahci). I rebooted in IDE mode, and then when it came to updating the firmware, it said the firmware was already updated. Anyone else have this problem?
42 REPLIES 42
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2009 06:56 AM
Mr.Wolf wrote:
MeY-ZiNG: After the FW update, did you switched back to the controler mode you had (when windows got installed), before you booted into windows?
Yes, immediately after seeing the message saying that the firmware was already updated (before going back to Windows). I'll try to figure out what's wrong tonight.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2009 04:09 AM
I also have this problem.
I still have the Intel SSD Toolbox installed so I ran that. It also reports the firmware as being 2CV102HD as does Crystal Disk Info.
When I tried to run the SSD management tools it reports the drive status as passed and as ready for use. When I run it though it fails saying "Error creating Intel Optimizer SSD files on the selected drive".
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2009 04:44 AM
This is a little off topic of this thread but I just enabled AHCI on my computer and my crystal mark disk scores are a hell of a lot better! Some people were saying this doesn't make that much of a difference, but as far as benchmarking goes, it really does.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-03-2009 04:06 PM
There is another thread in regards to this /thread/8934?tstart=0 http://communities.intel.com/thread/8934?tstart=0
The bottom line is ALL Intel SSD users should be running in AHCI mode if it is available to them.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-02-2009 03:18 PM
jimh wrote:
I also have this problem.
I still have the Intel SSD Toolbox installed so I ran that. It also reports the firmware as being 2CV102HD as does Crystal Disk Info.
When I tried to run the SSD management tools it reports the drive status as passed and as ready for use. When I run it though it fails saying "Error creating Intel Optimizer SSD files on the selected drive".
Has anybody else with the 'firmware already updated' issue attempted to run ssd optimizer? I didn't download before it was taken off the site, so can't test.
