Archive
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Intel 80 G2 poor burst rate ?

Intel SSD 80-G2 poor burst rate?What could be causing such a low burst rate?AHCI ich10R on windows 7. Flashed firmware before installing OS to 2CV102HD. I did notice this in HD Tune:ATA/ATAPI-0 - SATA IISupported: UDMA Mode 6 (Ultra ATA/133)Active: ...

idata by Esteemed Contributor III
  • 1969 Views
  • 0 replies
  • 4 kudos

Resolved! Use windows and intel ahci drivers simultaneously?

I have an X25-M G2 80GB (C:) running in windows 7 64-bit, along with 3 hdds (D:, E: and F:).Did a clean install of windows on the SSD (using default windows ahci drivers - msahci.sys), and all runs well, except for the fact that when I wake the compu...

idata by Esteemed Contributor III
  • 2958 Views
  • 4 replies
  • 3 kudos

X-25M G2 80GB -- RAID0 capped at 150mb/s

Hello,Recently purchased two X-25M G2 80GB SSD's to run in RAID0. My motherboard supports SATA II, but not RAID, therefore I purchased a Rosewill controller card, using chipset Sil3132. (http://www.rosewill.com/products/462/productDetail.htm http://...

idata by Esteemed Contributor III
  • 2211 Views
  • 2 replies
  • 3 kudos

Possible bug in Intel RST drivers

Until recently I was using the Intel Rapid Storage drivers 9.5.0.1037 with my G1 X18-m. I have since rolled back to the Microsoft AHCI drivers in Windows 7. I discovered that the Intel driver may have difficulties when bad sectors are detected on the...

idata by Esteemed Contributor III
  • 1846 Views
  • 1 replies
  • 4 kudos

PLEASE HELP! X18 Apple Bootcamp Windows 7 problem!

Hello All,I'm saddened to learn that my SSD is unable to be recognised when I try and install windows 7. I've been googling about and there is a firmware fix for this. Only that the bloody firmware fix doesnt seem to work on my mac mini.Can someone p...

idata by Esteemed Contributor III
  • 2669 Views
  • 4 replies
  • 1 kudos