Since the purchase of my Intel SSD drive (Intel SSD 335) I am unable to run the SSD Toolbox software. I have tried with the then-current version (3.1.0) and three consequent versions (3.2.0, 3.2.1 and lastly 3.2.3).
The issue is always the same - I install the software without problems, but after launching the application it crashes with the typical Windows' "application has stopped working" modal.
I have contacted support a few times already with this issue, but it's gone nowhere; today I performed two tests with the software:
I installed the SSD Toolbox on another computer, where it had no problem with running (note: there are only HDDs installed on said computer), while on my laptop (where my SSD is installed and used as the only/primary disc) the toolbox kept crashing (always referencing a faulty msvcr90.dll - multiple versions, removals, reinstalls or updates did not help at all.).
So, using Microsoft's Dependency Walker I ran the software on both PCs, with 'Profiling' option on and after reviewing the logs I found one difference - some libraries aren't being run/loaded on the 'faulty' machine. The diff of both logs is available at this link - http://www.diffchecker.com/j4p4joi4 http://www.diffchecker.com/j4p4joi4 - on the left is the log of the 'running' machine, on the right the faulty one.
They are pretty much the same (only the addresses change) until the line 1812, where the 'OK' machine runs a few wintrust.dll & setupapi.dll functions, while the other one doesn't at all. After few more lines, at 1850, an exception occurs on the 'faulty' one, which then propagates to the end of the log and the program termination.
I'm using (on both machines) Windows 7 64-bit. I'll be happy to supply more debug data if requested.
