cancel
Showing results for 
Search instead for 
Did you mean: 

SSD specifics request.

PPF4P
New Contributor

Hi there

Does anybody have specific information on page size and erase block size of the following SSD drives:

1. https://ark.intel.com/products/66249/Intel-SSD-520-Series-180GB-2_5in-SATA-6Gbs-25nm-MLC https://ark.intel.com/products/66249/Intel-SSD-520-Series-180GB-2_5in-SATA-6Gbs-25nm-MLC

Intel® SSD 520 Series

180GB, 2.5in SATA 6Gb/s, 25nm, MLC

2. https://ark.intel.com/en/products/94420/Intel-SSD-540s-Series-120GB-2_5in-SATA-6Gbs-16nm-TLC https://ark.intel.com/en/products/94420/Intel-SSD-540s-Series-120GB-2_5in-SATA-6Gbs-16nm-TLC

Intel® SSD 540s Series

120GB, 2.5in SATA 6Gb/s, 16nm, TLC

Please note, that I'm not asking about partition alignment etc. I need to know these parameters to optimize my filesystems.

Thanks

11 REPLIES 11

PPF4P
New Contributor

Hi Eugenio

Thank you for your reply

Given that Intel does not disclose Page and Block Sizes of their SSDs to public and having in mind Intel document titled "Partition Alignment of Intel ® SSDs for Achieving Maximum Performance and Endurance", is it correct to assume that Intel considers aligning partitions to 1 MB (per document referenced) by end-user to be sufficient for performance and endurance without the knowledge of Page and Block Sizes, which would enable end-users to configure filesystems on SSDs to arrange data in chunks equal to Block Size to minimise wear?

idata
Esteemed Contributor III

Hello PF4Public,

Please allow us some time to investigate and confirm if aligning partitions to 1MB would be beneficial for all SSD models.Best regards,Eugenio F.

idata
Esteemed Contributor III

Hello PF4Public,

We have updates regarding your inquiry. The information on the https://www.intel.com/content/dam/www/public/us/en/documents/technology-briefs/ssd-partition-alignme... partition alignment document is intended for Intel® SSD Data Center family, not consumer drives such as the Intel® SSD 540s and 520 Series. However, your drives have a similar structure and the recommendations there could apply to them as well. I was able to get authorization to share the page size for the Intel® SSD 540s, which is 16KB. As for the Intel® SSD 520, this is a legacy drive and available information is limited. Both drives sector size is 512 bytes.Best regards,Eugenio F.

PPF4P
New Contributor

Hi Eugenio

Thanks for your reply.

For anyone interested actual information follows:

I have tried flashbench on both devices and it seems that they both use 4K page size as there was no noticeable measurements' differences above 4K.

Also I have unscrewed my 540s Series SSD and identified that it uses one 256MB RAM chip and four of H27QEG8NDM5R chips, which per SK Hynix datasheet have a 4MB Block Size.

As for the other SSD - didn't unscrew it just yet.

idata
Esteemed Contributor III

Hello PF4Public,

Thanks for sharing this information, it is good to know you were able to find these details. However, please bear in mind that we don't recommend unscrewing your Intel® SSD. Doing so https://www.intel.com/content/www/us/en/support/articles/000005861/memory-and-storage.html voids the device warranty. Best regards,Eugenio F.