Announcements

The Solidigm Community will be discontinued on November 13, 2026.
For product Information, documentation, support, and other resources, please visit Solidigm Support.

Archive
cancel
Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Firmware Update from DVD?

Is it possible to burn the ISO image of a firmware update (02HD for X25M) to a DVD (instead of a CD) and then update the firmware from it?

idata by • Esteemed Contributor III
  • 3506 Views
  • 2 replies
  • 0 kudos

X25-M G2 80GB, Steam games freeze with AHCI mode enabled.

I have an Intel X25-M G2 80gb SSD, and Windows 7 Ultimate 64bit. I recently enabled AHCI through Windows using the steps in this guide. http://www.ithinkdiff.com/how-to-enable-ahci-in-windows-7-rc-after-installation/ http://www.ithinkdiff.com/how-to...

idata by • Esteemed Contributor III
  • 7318 Views
  • 8 replies
  • 4 kudos

Help, new to Intel SSD.

Sorry, I have a ton of questions I couldn't find an answer to all of them and some seemed to have conflicting posts.I have a 4 drive setup. They are all IDE mode.I replaced one with my new X25-m G2 160GB SSD. I unplugged the sata cables to all other...

MJohn26 by • New Contributor III
  • 5350 Views
  • 4 replies
  • 1 kudos

Resolved! Driver question for X25M-G2 80GB Windows 7

I am suspecting that my clean Windows 7 installation (with BIOS AHCI enabled priorly) doesn't support trim function. My drive is connected to Intel ICH8M-E/M SATA AHCI Controller, using driver file iaStor.sys. As far as I understand, this is not Wind...

idata by • Esteemed Contributor III
  • 4413 Views
  • 3 replies
  • 1 kudos