I made a boo-boo and upgraded my Seagate backup drive's firmware withing windows while my 160GB X25-M G2 SSD was boot device and when I rebooted after a successful flash, I get a non-system disk, press any key... error. I can press any key and the s...
I have had this drive for a couple of months and it has been working great. My little issue is shutting down the system. It takes appox. 12 seconds to shut down. It usually only take about 4 seconds to shut down after running the toolbox, which I ...
Sorry, I have a ton of questions I couldn't find an answer to all of them and some seemed to have conflicting posts.I have a 4 drive setup. They are all IDE mode.I replaced one with my new X25-m G2 160GB SSD. I unplugged the sata cables to all other...
Nothing?Well, I tried using the Win 7 Ult x64 install disk to do a repair and it reported there was something to fix, but all it did was create a dual boot menu that I didn't want.I'm open to any suggestions. as it is, I will have to reinstall win7 ...
Defineately not a solution. I'd call it more a band aid. I shouldn't need to run toolbox constantly. I'm hoping this system restore fixes until they figure out the issue with system restore. If this don't work, then I may try RST and see if the n...
as stated in my original post, my only real concern is my shut down speed increainng from 4 to 12 seconds, which is 300% decrease in speed. isn't 300% a lot?Hopefully disabling system restore fixes the issue as a lot of complaints arise from this fe...
iaStor that comes with the newer RST that replaces IMSM. The new version is 9.6.0.1014. I was wondering how well it works. I've a lot of users saying they have speed loss, while others say it's about the same. I see people saying it supports sing...
The status menu only shows when the optimizer was last run, not when trim was last run.AS SSD shows normal performance, just the shut down times are unusually long, 3 times as long as if I run the toolbox.are you saying TRIM isn't supported in the ne...
