I think my sequential read speed (on X25-M G2 80GB) is low, it's 134 MB/s,
shouldn't it be above 200 ?
I measured it before and after the new firmware update, it's the same.
I'm running Win7 32bit (for few months now, not a fresh installation)
Solved! Go to Solution.
I had that happen to me; I fixed mine by moving my SSD to a different SATA port on the motherboard; seems my ASUS P6T SATA 0 & 1 are not cut out for the SSD drives. Immediately after moving the SSD to SATA Port 2 I was seeing 240-260 MB/sec depending on the particular disk performance test tool used.
hm, that's interesting,
I have Intel D875PBZ motherboard (P4), it's an old (but good) mb, so this could be the prob. with mb ?
I'll try different port (there are only 2 on this mb), I also have the PCI SATA controller but I doubt it would be better to connect it there..
thanks for the tip