https://community.solidigm.com/t5/solid-state-drives-nand/discrepancy-in-end-to-end-error-detection-threshold/m-p/20443#M8556 <P>Hi Jim,</P><P></P><P>The discrepancy should not be an issue, but the firmware version on your drive indicates that the drive is a pre-production unit. You will need to check with your source for the SSD for support.</P> Thu, 07 Feb 2013 18:35:38 GMT KenF_Intel 2013-02-07T18:35:38Z https://community.solidigm.com/t5/solid-state-drives-nand/discrepancy-in-end-to-end-error-detection-threshold/m-p/20442#M8555 <P>I have a SSD 520 Series 180GB. Firmware version is LCSi.</P><P></P><P>The SMART attributes reported by the SSD Toolbox says the B8 End-to-End Error Detection Count threshold is "97". However, the Help information says the threshold is "90". </P><P></P><P>Is this a problem?</P><P></P><P>Any guidance is appreciated.</P><P></P><P>Jim</P> Sun, 25 Nov 2012 04:22:15 GMT https://community.solidigm.com/t5/solid-state-drives-nand/discrepancy-in-end-to-end-error-detection-threshold/m-p/20442#M8555 idata 2012-11-25T04:22:15Z https://community.solidigm.com/t5/solid-state-drives-nand/discrepancy-in-end-to-end-error-detection-threshold/m-p/20443#M8556 <P>Hi Jim,</P><P></P><P>The discrepancy should not be an issue, but the firmware version on your drive indicates that the drive is a pre-production unit. You will need to check with your source for the SSD for support.</P> Thu, 07 Feb 2013 18:35:38 GMT https://community.solidigm.com/t5/solid-state-drives-nand/discrepancy-in-end-to-end-error-detection-threshold/m-p/20443#M8556 KenF_Intel 2013-02-07T18:35:38Z